Advertisement
Press the ENTER button and the display will show the version of
software of the unit. To go back to the functions press the MENU
button.
Reset
Press the MENU button to select
all channels of the unit will return to their standard position.
4. How To Control The Unit
1. Master/slave built-in preprogram function
2.Easy controller
3. Universal DMX controller
There is no need to turn the unit off when you change the DMX
address as new DMX address setting will take effect at once. Every
time you turn the unit on, it will show "
move all the motors to their 'home' position and you may hear some
noises for about 20 seconds. After that the unit will be ready to
receive a DMX signal or run the built in programs.
4.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will
control the other units to give an automatic, sound activated show.
The other units must be set to either Slave 1 (normal) or Slave 2
(2 light show) mode. A DMX cable between the units for daisy
chaining is needed.
2-light show
In slave mode, Slave 1 means the unit works normally and Slave
2 means 2-light show. In order to create a great light show, you can
set Slave 2 on the second unit to get contrast movement to each
other, even if you have two units only.
4.2 DMX Controller
Optimum control of the fixture can be achieved by using a universal
. Press the ENTER button and
"on the display and
DMX controller, you will need to set a DMX address from 1 to 512 so that
the units can receive a DMX signal. Press the MENU button until
is showing on the display. Press the ENTER button and the display will
blink. Use the DOWN and UP buttons to change the DMX-512 address.
Once the address has been selected, press the ENTER button to confirm.
To go back to the functions without any changes press the MENU button
again. Press and hold the MENU button one second or wait for one
minute to go back to the main menu.
Please refer to the below diagram to address your first 4 units：
Channel
Unit 1
mode
Address
1 channel
1
8 channel
1
10 channel
1
4.3 DMX 512 Configuration
1 CHANNEL MODE
1
Function
8 CHANNEL MODE
Channel
Function
Pan
1
2
Tilt
3
4
Gobo
Unit 2
Unit 3
Unit 4
Address
Address
Address
2
3
9
17
11
21
000-007
No function
008-255
Sound Active
Value
Percent / Setting
000-255
0~100%
0~100%
000-255
000-007
Gobo 1 (Open)
008-015
Gobo 2
016-023
Gobo 3
024-031
Gobo 4
032-039
Gobo 5
040-047
Gobo 6
048-055
Gobo 7
4
25
31
Advertisement
