Full Cut Test - Brother PT-D600 Service Manual

1.2.5 Full Cut Test

Checks the full cut operation with the cleaning tape. If the factory inspection mode [6] (Full CUT
Mode) has been completed already, this inspection is not necessary.
(1) Open the cover of the machine and set the cleaning tape.
(2) Check that the inspection item is highlighted in yellow, and press the [Run] button.
(3) Check if the tape is fed and cut properly. The number of "FEED" and "CUT" appears on
the Status field when the tape is cut. Feeding and cutting for the specified number of times
completes the inspection. In this inspection, the specified number is once.
NOTE: Quit the inspection by pressing the [NG] button when something is wrong with the
operation.
 Inspection errors
• "Tape type NG."
This error occurs when no media is found. Check that the media is set. If this error occurs
even the media is set, close the cover and check the status of the side sensor.
• "Feed and Cut check is NG."
An error occurred due to the cutter operation or open cover during the inspection. Fix the
error and perform the inspection again.
APP 1 - 6