Brother PT-D600 Service Manual page 76

If this message appears on the
computer screen:
Communication error between PC
and P-touch.
Not enough memory to print
document.
Not enough disk space to spool
document.
Sending...
Printing...
Remove the tape from the output
slot. (PT-D600 only)
Error of unknown cause occurred. Turn the printer off, then on again.
Cover open.
Cannot print because printer is too
hot. Wait until printer cools down,
and then restart printing.
The tape cassette type is different. After installing the appropriate tape cassette
The tape cassette type is different. After installing the appropriate tape cassette
Do this:
Check that the P-touch is connected to your
computer with the USB interface cable (that
comes with the P-touch). Also check the cable
for weak connection.
Make sure that the P-touch is turned on. If any
communications error has occurred, turn the P-
touch off and then on.
Wait until any other application(s) is finished and
then try to print again.
Ensure sufficient disk space.
Print data is being sent. Please wait.
Printing. Please wait.
After removing the tape,
click [Resume] in Print Monitor.
If the error cannot be resolved, repairs will be
necessary.
Close the cover.
Wait until printer cools down, and then restart
printing.
(heat shrink tube), click [Resume] in Print
Monitor.
(TZe or HGe tape), click [Resume] in Print
Monitor.
IV - 3