Configuration; Configuration Procedure; Changing The Display Language - SMA 5000TL Operating Manual

SMA Solar Technology AG
8

Configuration

8.1

Configuration Procedure

Once you have commissioned the inverter, you may have to adjust various settings via the rotary
switches in the inverter or via a communication product. This section describes the procedure for
configuration and gives an overview of the steps you must perform in the prescribed order.
Procedure
1. If the display language is not set correctly, adjust the set-
tings.
2. If you want to integrate the inverter into a Speedwire net-
work, connect the inverter to the network.
3. Integrate the inverter into the network.
4. To manage the PV system data or to set the inverter pa-
rameters, capture the inverter in a communication product.
5. Change the system time and system password.
6. If a residual-current device with a tripping threshold of
30 mA was specified and has been installed, set the trip-
ping threshold of the residual-current device.
7. If using the multifunction relay, ensure that the operating
mode is set correctly and adjust any further settings for the
operating mode as necessary.
8. For partially shaded PV modules and depending on the
given shading situation, you should set the interval at
which the inverter optimizes the MPP of the PV system.
8.2

Changing the Display Language

If the language for the country data set is not the language you want to use, you can change the
display language as follows:
Procedure:
1.
Danger to life due to high voltages
• Disconnect the inverter from all voltage sources and open the enclosure lid (see
Section 10, page 57).
Operating Manual
8 Configuration
See
Section 8.2, page 47
Section 8.3, page 48
Section 8.4, page 49
Manual of the communica-
tion product at www.SMA-
Solar.com
Manual of the communica-
tion product at www.SMA-
Solar.com
Section 8.7, page 51
Section 8.8, page 51
Section 8.9, page 52
STP5-12TL-20-BE-en-15 47