Rear - Sony RM-IP500 Operating Instructions Manual

Rear

9
12 3 4
A
Anti-theft wire attachment point
Attach a wire to prevent theft.
B
Ground connection
C GPI I/O connector
Used as a tally input from an external device or as a
contact output connector of the selected camera
number.
D LAN (network) connector (RJ-45)
Use for LAN connection.
Connect a LAN hub (10BASE-T/100BASE-TX)
using a LAN cable (category 5 or higher).
When a link is established, the green indicator
lights, and it blinks during communication. For
100BASE-TX connections, the yellow indicator
lights.
Notes
• For safety, do not connect the connector for
peripheral device wiring that might have
excessive voltage to this port. Follow the
instructions for this port.
• When you connect the LAN cable of the unit to
peripheral device, use a shielded-type cable to
prevent malfunction due to radiation noise.
E VISCA RS-422 connector (RJ-45)
Used for VISCA RS-422 serial connection.
F
12V! (DC power supply input)
connector
Connect to an AC power adapter.
G Cord clamper
Clamp the cord of the AC power adapter to prevent
the cord from being pulled out of the unit.
1 Release the lock of the cord clamper.
9
5 6 7 8
2 Connect an AC adapter.
3 Thread the cord of the AC power adapter
through the cord clamper, then close the lock.
H Power switch
Turns the power ^ (on) and 1 (off).
Note
When the unit is mounted in a console desk, turn
the power on/off using the main power supply of
the console desk.
I Screw holes
Mounting points available for use when not
mounting the unit on a flat surface.
Screw holes are provided on all sides, with the
screw holes on the front, left, and right sides
protected by covers (six locations).
10
Cord clamper
Cord of the AC adapter