Menu Operations; Basic Menu Operations - Sony RM-IP500 Operating Instructions Manual

Menu Operations

The menu control block is used to configure the device
settings and camera settings.
One of the three menus (RM menu, camera menu, or
FUNCTION menu) is always selected.
When the RM menu or FUNCTION menu is selected,
the menu items and settings are displayed on the LCD
panel.
When the camera menu is selected, nothing is displayed
on the LCD panel.
Note
Except for the OPERATION menu, return to the top
menu when operating a camera. If a lower-level menu is
displayed, cameras cannot be operated.
A RM menu
This menu is used to configure picture quality
adjustments and compensation functions on target
cameras, configure the unit, execute/configure auto
assign functions on cameras, and for performing
configuration from a connected setup PC.
When the RM menu button is turned on, RM menu
setup mode is invoked and the top menu is
displayed on the LCD panel.
For details, see "RM Menu List" (page 43).
B Camera menu
Turns the superimposed output of the camera setup
menu on the camera image on/off. When turned on,
operation of the setup menu on the camera using the
knobs and buttons on the menu control block and
the joystick is enabled.
For details, see "Operating the Camera Setup Menu
from the Unit (Camera Menu Operation Mode)"
(page 35).
C FUNCTION menu
This menu is used to configure functions assigned
to buttons using shortcuts.
For details, see "Setting Specific Functions using
Shortcuts (FUNCTION Menu)" (page 37).

Basic menu operations

Buttons and knobs used for RM menu
operations
Operation
1
Display the top
menu.
2
Select a top
menu item.
3
Confirm the
menu item
selection.
Select a setup
menu item.
Confirm the
setup menu
item selection.
Select a setup
menu sub item.
Change the
setting of the
setup menu sub
item.
Confirm the
changed
setting.
Save settings.
Go back one
level in the
menu.
*1 A confirmation message appears for settings that display an
EXEC item.
*2 If the CANCEL button is pressed before attempting to save,
the menu display goes back one level and restores the
existing setting.
*3 For details about items saved with a preset number, refer to
the operating instructions of each camera.
12
Buttons and knobs used
OPERATION CONFIG, AUTO IP SETUP,
menu or MAINTENANCE menu
Press the RM MENU button.
Turn the SELECT knob.
Press the SELECT button.
Turn the SELECT knob.
Press the SELECT button.
Turn the SELECT knob.
Turn the VALUE knob.
Confirmation Press the VALUE button.
not required.
Saved on the Save on the unit.
camera using
the camera
preset memory
*3
function.
Press the Press the CANCEL
*2
CANCEL button.
button.
*1