Installation; 2_1 Safety; 2_2 Security Of Your Terminal - Ingenico iUC280 Owner's Manual

2 Installation

2_1 Safety

Power on/Power down
To power on or power down the iUC280/285/250 connect or disconnect the USB cable.
Lithium battery
The iUC280/285/250 is fitted with a lithium battery which is not accessible to the user. Only a qualified
technician may be authorized to open the unit and change this component.
For switzerland annex 2.15 of SR 814.81 applies for batteries.
SAM, MMC connectors
They are operator accessible parts.
This is an Electrostatic (ESD) sensitive area and ESD precautions must be taken when fitting it. As a
minimum, the operator should be "Electrostatically Discharged" via his/her hand to a suitable safe
metallic earthing point prior to opening this area.
Connections to external equipment and circuits
All external circuits and equipment connected to iUC280/285/250 should be Safety Extra-Low Voltage
circuits according to clause 2.2 of Standards
IEC60950-1:2005 Edition 2 and EN60950-1:2006+/A11:2009/A1:2010/A12:2011
Operating conditions
Temperature -20°C to +65°C

2_2 Security of your terminal

Your device fulfils current applicable PCI PTS security requirements.
Upon receipt of your terminal you should check for signs of tampering of the equipment. It is strongly
advised that these checks are performed regularly after receipt. You should check, for example: that
the keypad is firmly in place; that there is no evidence of unusual wires that have been connected to
any ports on your terminal or associated equipment, the chip card reader or any other part of your
terminal. Such checks would provide warning of any unauthorised modifications to your terminal, and
other suspicious behaviour of individuals that have access to your terminal. Your terminal detects any
"tampered state". In this state the terminal will repeatedly flash the message" Alert Irruption!" and
further use of the terminal will not be possible. If you observe the "Alert Irruption!" message, you
should contact the terminal helpdesk immediately.
You are strongly advised to ensure that privileged access to your terminal is only granted to staff that
have been independently verified as being trustworthy.
The terminal must never be put in or left at a location where it could be stolen or replaced by another
device.
Product must be mounted vertically and at appropriate height to keep IC card reader slot in full view
for the card holder during all the payment transaction.
You are strongly advises to perform regular checks on the chip card reader.
Ingenico document - Reproduction or disclosure prohibited without written authorization
4/10
Please check document validity before using