Test Run From Remote Controller; Simple Remote Controller - Fujitsu AUXB04GALH Service Manual

1-2-7 Test Run From Remote Controller

1. Standard wired remote controller
Stop the indoor unit. Push the
button simultaneously for more than two seconds.
The air conditioner will start to conduct a test run and "
the remote controller display.
However, the , setting button does not have function,
but all other buttons, displays, and protection functions will operate.
Perform the test operation for 60 minutes.
To stop test run, push the START / STOP button of the standard wired remote
controller.
For the operation method, refer to the operating manual and perform operation
check.
Check that there are no abnormal sounds or vibration sounds during test run
operation.
2. Standard wireless remote controller
Press the TEST RUN button on the remote controller, while the air conditioner is running.
To end test run operation, press the remote controller START / STOP button.
When the air conditioner is being test run, the OPERATION
and TIMER lamps of indoor unit flash slowly at the same time.

3. Simple remote controller

Stop the indoor and outdoor units. Push the remote controller
simultaneously for more than three seconds. The air conditioner will start to conduct a test
run and " " will display on the temperature display.
However the setting button does not have function but all other buttons,
displays and protection functions will operate.
To stop test running press the
For the operation method refer to the operating manual and perform operation check.
Check that there are no abnormal sounds or vibration sounds during test run operation.
button and
" will display on
button of the simple remote controller.
01-10
TIMER MODE
CLOCK ADJUST
SET BACK
TIMER DELETE
START / STOP button
TEST RUN button
button and button
UTY - RNK
SET TEMP .
START / STOP
FAN MODE
DAY
DA Y OFF
TIMER SET
UTY - LNH
MODE FAN
START
STOP
SET
ECONOMY
SET
FIL TER RESET
SET
TEMP .
SLEEP SWING
TIMER
TIMER MODE
CLOCK TEST RESET
ADJUST RUN
UTY - RSK
SET