Timer Control; Wireless Remote Controller - Fujitsu AUXB04GALH Service Manual

3-7 TIMER CONTROL

3-7-1 Wireless Remote Controller

UTY - LNH
There are following 4 kinds of timer modes are available.
ON Timer
OFF Timer
PROGRAM Timer
SLEEP Timer
1. ON / OFF TIMER
The timer functions cannot be used when this controller is used together with the remote controller (Wired type).
A beeping sound is made when a signal is received.
To set the ON / OFF timer
Press the START/ STOP button to start the air conditioner, and then proceed as follows.
1
Press the TIMER MODE button to select
"OFF TIMER" or "ON TIMER"
CANCEL
PROGRAM TIMER (OFF
2. PROGRAM TIMER
To set the PROGRAM timer
Press the START/ STOP button to start the air conditioner, and then proceed as follows.
1
Select "OFF TIMER"
4
Adjust the ON time.
(About 5 seconds later, the entire display.
will reappear.)
To cancel the TIMER
Select "CANCEL".
The air conditioner will return to normal op-
eration.
3. SLEEP TIMER
To set the SLEEP timer
Unlike other timer functions, the SLEEP timer is designed to set the duration of time in which the unit does not operate.
The SLEEP timer can be set regardless of whether the indoor unit is operating or stopped.
1
(Both the indoor unit's OPERATION indi-
cator lamp (green) and the TIMER indi-
cator lamp (orange) will light.)
To change the timer settings
1
Press the SLEEP button
once again.
OFF TIMER ON TIMER
ON, OFF ON)
2
Adjust the OFF time.
2
Set the time using the
TIMER SET buttons.
03-17
2
3
5
Select "PROGRAM TIMER"
(Either OFF
will display.)
(If the ON timer has been se-
lected to operate first, the unit
will stop operating at this point.)
*To change operating conditions
If you wish to change the operating conditions (ON/OFF,Mode,
Fan Speed, Temperature Setting), after making the time set-
ting, wait until the entire display reappears, then press the ap-
propriate buttons to change to the desired operating condition.
* Even ON/OFF and Sleep timer are valid.
2
*To cancel the TIMER
Select "CANCEL".
The air conditioner will re-
turn to normal operation.
* Even ON/OFF and Program timer are valid.
Adjust the OFF or ON time.
(About 5 seconds later, the
entire display will reappear.)
Select "ON TIMER"
ON or OFF ON
Adjust the OFF time.
(About 5 seconds later,the
entire display will reappear.)
*To stop air conditioner
operation during
timer operating