Fujitsu AUXB04GALH Service Manual page 25

Function
Function
number
*1 Auto
40
restart
Cool Air
43
Prevention
External
46
control
Error
report 47
target
Fan setting
when cooling 49
thermostat OFF
*1 : Auto restart is an emergency function such as for power failure etc.
Do not start and stop the indoor unit by this function in normal operation.
Be sure to operate by the control unit, converter or external input device.
Setting number Default
00 Enable
01
Disable
00 Super low
Follow the setting
01 on the remote
controller
00 Start/Stop
01 Emergency stop
02 Forced stop
00 All
Display only on
01 central remote
control
Follow the setting
00
on the remote
controller
01 Stop
Enable or disable automatic system restart after a power outage.
Restrain the cold airflow with making the airflow lower when starting
heating operation. To correspond to the ventilation, set to 01.
Allow an external controller to start or stop the system, or to perform
an emergency stop, or to perform a forced stop.
* If an emergency stop is performed from an external controller, same
refrigerant system will be disabled.
* If forced stop is set,indoor unit stops by the input to the external input
terminals,and Start/Stop by a remote controller is restricted.
Change the target for reporting errors. Errors can either be reported in
all locations, or only on the wired remote.
When set 00, Indoor unit is continued operation based upon Central
remote controller or individual controller set.
Once indoor unit received signal from External controller, Indoor unit
changed Fan mode forcibly.
When set 01, Indoor unit is continued operation based upon Central
remote controller or individual controller set.
Once indoor unit received signal from External controller, Indoor unit
stop forcibly.
Connection of the wired remote controller
(2-wire type or 3-wire type) and switching its thermistor are necessary.
01-20
Details