Print Head - MIMAKI TX300P-1800 Print Manual

Prepare Tx300P-1800
Following the procedures below, prepare Tx300P-1800.
1.
Connect a PC in which the attached Ras-
terLink is installed with Tx300P-1800.
• For details, refer to
of Tx300P-1800 Operation
2.
Turn on the power supply of Tx300P-1800.
• For details, refer to
of Tx300P-1800 Operation
3.
Before setting a media, check the height of

print head.

• For details, refer to
Height" of Tx300P-1800 Operation
• Adjust the Height-adjusting lever depending on the media
to be used.
4.
Set the media.
• When setting the roll media
• When setting the leaf media :
5.
Perform a test printing.
• Check if discharging defect such as nozzle clogging exists or not.
• For details, refer to
6.
Perform a media correction.
• Correct the feeding rate of media.
• For details, refer to
ual.
7.
Perform a dot position correction.
• Correct the ink drop position.
• For details, refer to
Manual.
Chapter 1 "Connecting Cables"
Manual.
Chapter 2 "Turning the Power ON"
Manual.
Chapter 2 "Adjusting the Head
Manual.
: Chapter 2 "Using the tension bar to set the roll media" of
Tx300P-1800 Operation Manual
Chapter 2 "Seting roll media without using tension bar" of
Tx300P-1800 Operation Manual
Chapter 2 "Setting leaf media" of Tx300P-1800 Operation
Manual
Chapter 2 "Test Printing" of Tx300P-1800 Operation
Chapter 2 "Setting of Media Correction" of Tx300P-1800 Operation Man-
Chapter 2 "If the Positions of Dots Shift..." of Tx300P-1800 Operation
- 3 -
USB cable
Power switch
Height-adjusting handle
Manual.