Rcom REPTILE PRO 90 User Manual page 10

North America Sales & Service www.RcomCo.com
3. Incubation
It is good for reptile vermi not to be reused
after incubation. Incubation rate falls
notably because of Bacteria
contamination. [It is possible to
purchase at the place you purchased.]
▶ Bury about 1/2 of egg to be incubated in
reptile vermin to fix egg. [Fig-4]
(During incubation, check the state of
eggs at least once a week and remove
unfertilized eggs, growth-stopped eggs
and moldy eggs.)
When reptile laid eggs, they should be moved to the
incubator as the first direction when laying eggs was.
It is convenient to making a marking on the egg in order
for them not to be changed.
▶ Set the environment of egg to be incubated to install the
prepared tray in the inside of incubator and close the lid
of sight glass tightly.
In case that sight glass and water cap weren't closed
completely, temperature and humidity aren't normally
operated. Therefore, please be careful.
▶ Check water for humidification every day and makeup
water as seen in [Fig.-5]. Then, it is necessary to stop it
when the Styrofoam ball in the inside comes up.
Even though the marking humidity of incubator is normal,
it is necessary to check the humidification state of
vermiculite at least once a week and check the state
of vermiculite once a month to makeup 400cc of water
as seen in [Fig.-6].
▶ In case that the humidity of incubator inside isn't controlled
into high humidity of RH 90~95% according to the
environment of incubation room, pour 75cc of water for
humidification on each edge of 4 tray sides for incubation
where without any egg meddle [Fig.-6] and pour 1000cc
of water on ⓒ of [Fig-7] main body(bottom).
In case of humidifying inside humidity over RH 60%,
be sure to fill main body(bottom) of [Fig.-7] with 1000cc
of water, and in case of setting incubation humidity
into less than RH 60%, it isn't necessary to pour water
on the bottom. In case of incubating at low humidity,
water may be created naturally on the bottom by dew
condensation. Therefore, it is necessary to check
sometimes to remove it.
10
Rcom Reptile Incubator Pro 90 User Manual
(1) Preparation for Incubation /
How to Start Incubation
Please bury about 1/2.
100cc
100cc
Marking
[Fig-4]
[Fig-5]
100cc
100cc
[Fig-6]
1000cc
[Fig-7]
DIGITAL INCUBATOR