MAINTENANCE
To install the Display
1. Verify that no damage exists on the LCD glass. Install the protective film back
2. Locate the display above the chassis and slide left side of LCD under chassis
3. Carefully install the display holder. Verify that the holder is securely snapped
4. Remove the protective film from the LCD glass.
5. Install the Keypad Board and Main Board. Refer to "Removing and Installing
DETAIL A
MTP850 TETRA Handportable Terminal / Basic Service Manual
in place.
tab and onto left locating pin and ease into place. Verify that the display is
inserted into the 2 location pins.
into the slot.
the Keypad Board and Main Board" on page 6-19.
Figure 16 Display Removal and Installation 1
Figure 17 Display Removal and Installation 2
SEE DETAIL A
6 - 21