Installing The Brita Tap - Brita WD3030 Manual

3.3 Step 3: Installing the BRITA Tap
To install the BRITA Tap, fi rstly ensure you have all the components
required.
Please, make sure that there is enough room and access
!
under the sink to allow for the installation of the fi lter head
and cartridge, and to connect the two supplied hoses.
The supplied hose for connection to the cold water supply
requires the availability of an already installed ½" isolation or
angle valve. Before installation, please ensure you have such
a free ½" isolation or angle valve and that it is working prop-
erly (closeable to 100 %). If not, please contact a licensed
!
plumber. In accordance with regulations, the isolating valve
which is included in your kit must be installed at the point
of connection to the water supply before the fi lter system
inlet hose. Behind the isolating valve a pressure limited valve
must always be installed to ensure the right function of the
cartridge.
WD 3020
1. BRITA Tap with 3 hoses
2. BRITA Tap Cartridge Status Indicator
1.
3. O-Ring
4. Shank
5. Joint (Is only necessary for installa-
2.
(fi g. 5) 6. Flat Gasket
3.
7. Flange
8. Brass nut
4.
5.
6.
7.
8.
1014663-001_GA_BRITA_Tap_AU.indb 7 1014663-001_GA_BRITA_Tap_AU.indb 7
tion of the dispenser if you directly
mount it onto your sink. If you
mount it onto your countertop-plate,
you do not necessarily need this
part. It helps stabilizing the tap at
your sink)
WD 3030/ WD 3040
1. BRITA Tap (design may differ) with
3 hoses
2. BRITA Tap Cartridge Status Indicator
3. Base
4. Shank
5. Joint (Is only necessary for installa-
tion of the dispenser if you directly
1.
mount it onto your sink. If you
mount it onto your countertop-plate,
2.
you do not necessarily need this
part. It helps stabilizing the tap at
your sink)
3.
6. Flat Gasket
7. Flange
8. Brass nut
4.
5.
6.
7.
8.
(fi g. 6)
A First of all, remove your existing kitchen tap.
a) Turn off the cold and hot water supplies
b) Please make sure you release any pressure by opening all
levers.
!
No water should run through the existing kitchen tap.
c) Unscrew the existing hoses from the cold and hot water
supply.
We recommend placing a suitable container under the water
!
supply as there will be water left in the hoses which will run
down when you unscrew them.
d) Unscrew your kitchen tap – there is no standard mounting but
in general a pipe wrench will help you to unmount it.
e) Pull out both your kitchen tap and the hoses.
B You're now ready to install the BRITA Tap (see fi g. 5 and fi g. 6).
First of all, screw the shank (4) into the Brita Tap (1).
Screw the hoses into the dispenser (see fi g. 7). Screw the M8 con-
nector of the hose with the blue stripe into the hole C.
7
ENGLISH
28.04.15 15:25 28.04.15 15:25