Table of Contents
Advertisement
locking mechanism is the locked position before closing
the door.
Important: Pushing the fire back in with the
locking mechanism closed can cause the fire
to jam. Make sure the fire is securely locked in
place prior to starting.
5.3
Understanding the Remote Control
18:00
20°C
1
4
Button Number Function
1
Decrease general values
2
Increase general values
3
Turns fire ON/OFF
4
Access to temperature adjustment
menu
5
Access to power level adjustment menu
6
Multi-function
7
Multi-function (Enter or Select)
5.4
Synchronising the Remote Control
with the Pellet Fire
All insert fires come with a remote-control (radio-wave)
handset and receiver. Sometimes, due to interference
in the power supply or from other electrical household
appliances (microwave ovens, satellite decoders, mobile
phones) or replacing the batteries in the remote the
connection between the fire and the handset may be
interrupted or suffer interference. If this happens, the
following operations must be carried out to reinstate the
connection:
Note: Make sure the remote has good batteries installed.
We recommend replacing the batteries at the beginning
of each season. Batteries can be removed if the fire is not
being used for prolonged periods, however the remote
will probably need re-synchronising once batteries are
Page 5
P-5
OFF
2
3
5
6
7
reinstalled.
3.
Switch the power to the fire off at the mains switch.
4.
Press the triangle keys 1 and 2 on the handset
together for about 3 seconds. The display will show
"SCEGLI UNITA 0"
5.
Using triangle key 2, select the unit frequency to be
loaded (0 , 1 , 2 , 3 ) Note: 0 or 1 are usually the
best but different houses may work better on other
settings.
6.
Switch the power to the fire back on (the fire must
be pushed back into its cradle when this is done) .
7.
Press the red button quickly after tuning the power
on.
8.
If the operation is successful, UNIT LOADED 0, 1, 2
or 3 will appear on the handset. You may now need
to turn the power to the fire off and back on again to
refresh the connection with the remote.
5.5
Switching on the Stove
1.
Ensure burn pot is clean and the burn pot holes are
visible.
2.
Ensure the hopper is full of wood pellets.
3.
Slide the heat exchange cleaner in and out three
times.
4.
To turn unit on hold down button '3' (ON/OFF)
5.
Control Screen will show START.
6.
To change the Power setting, first press [5] then use
buttons [1] or [2] to adjust the heat output of the fire.
7.
To change the Thermostat Setting, first press [4]
then use buttons [1] or [2] to adjust the thermostat
setting.
8.
To turn unit off hold down button [3] for three
seconds.
9.
Control Screen will show FINAL CLEANING.
7
Hide quick links:
Advertisement
Chapters
Table of Contents
