Warranty Exclusions - Ravelli Camino Owners & Installation Manual

10.3

Warranty Exclusions

This warranty does not cover the following:
• Changes in surface
As a heating appliance, some changes in colour of
interior and exterior surfaces may occur. This is not a
and is not covered under warranty.
• Damage to printed, plated, or enamelled surfaces
caused by
melted items, or other external sources and residues
left on the plated surfaces from the use of abrasive
cleaners or polishes.
• Repair or replacement of parts that are subject to
normal wear and tear during the warranty period.
These parts include: paint, gaskets, FIREX,
guides, and the discolouration of glass.
• Minor expansion, contraction, or movement of certain
parts causing noise. These conditions are normal and
complaints related to noise are not covered by this
warranty.
• Damages resulting from: (1) failure to install, operate
or maintain the pellet
installation instructions, operating instructions and
data plate furnished with the pellet
install the pellet in accordance with local building
codes; (3) shipping or improper handling; (4) improper
operation, abuse, misuse, continued operation with
damaged, corroded or failed components, accident,
or improperly/incorrectly performed repairs; (5)
environmental conditions, inadequate ventilation,
negative pressure, or drafting caused by tightly sealed
constructions,
handling devices such as exhaust fans or forced air
furnaces or other such causes; (6) use of fuels other than
those in the operating instructions;
(7) installation or use of components not supplied
with the pellet or any appliance not expressly
authorised and approved by Pellet
Ravelli's ; (8)
of the electrical power supply to the pellet
• Non Pellet Fire Solutions
hearth components or other accessories used in
conjunction with the appliance.
• Any part of a pre-existing
• Pellet Fire Solutions / Ravelli
this warranty does not extend to the pellet
capability to heat the desired space. Information is
provided to assist the consumer and the dealer in
selecting the proper appliance for the application.
Consideration must be given to appliance location
and environmental conditions,
insulation and air tightness
of the structure.
as a result of normal use.
accidents, misuse, scratches,
in accordance with the
(2) failure to
make-up air supply, or
Fire Soluions
n of, interruptions to or
approved venting components,
system
's obligation under
The warranty is void if:
The pellet
atmospheres contaminated by chlorine,
damaging chemicals. Over
not limited to, warped plates or tubes, rust coloured cast
iron, bubbling, cracking and discolouration of steel or
enamel
The pellet
dampness or condensation.
There is any damage to the pellet
due to water or weather damage which is the result of, but
not limited to, improper chimney or venting installation.
The owner's exclusive remedy and Pellet
Solutions / Ravelli's
warranty, under any other warranty, express or
implied, or in contract, tort or otherwise, shall be
limited to replacement, repair, or refund, as
above. In no event will Pellet
be liable for any incidental or consequential
damages caused by defects in the appliance. Some
countries do not allow exclusions or limitation of
incidental or consequential damages,so these
limitations may not apply to you. This
you specific rights;
which vary from
EXTENT PROVIDED BY LAW, Pellet
Ravelli MAKES NO EXPRESS WARRANTIES OTHER
THAN THE WARRANTY SPECIFIED HEREIN. THE
DURATION OF ANY IMPLIED WARRANTY IS LIMITED
TO DURATION OF THE EXPRESSED WARRANTY
SPECIFIED ABOVE.
/
has been or operated in
can be
is subjected to prolonged periods of
or other components
sole obligation under this
Fire Solutions
warrant
you may also have other
country to country EXCEPT
Fire
or other
by, but
Fire
/ Ravelli
y gives
rights
TO THE
Solutions /
Page 18
19