Operating Instructions; Safety Devices; Operating Precautions; Setting Up Your Pellet - Ravelli Camino Owners & Installation Manual

5.6

Operating Instructions

The heater is completely automated and will self-regulate
off phase, guaranteeing safe functioning. The burn pot
used for combustion allows most of the ashes produced
by the combustion of the pellets to fall into the lower ash
pan. However, it is recommended that you check the burn
pot every day, as not all pellets have high standards of
A special air-circulation function facilitates self-cleaning
avoided after a few hours of functioning.
Pellets with a diameter of 6mm, manufactured to the
AS/NZS 4014.6 or higher must be used with the stove.
5.7

Safety Devices

so that, in the case of breakage of one of the individual
6.
mode - press button 3 to achieve this. Some operations
the wrong language set see "6.4 Menu Three - Select
Language (Setting the Language)" on page 10.
6.1

Menu Descriptions

menus. Some of these menus are accessible by the
user, others are protected by a password and accessible
Press button [7] for 3-4 seconds to access the menus,
then use buttons [1] and [2] to scroll through the options,
and button [7] to Enter/Select.
The menus are as follows:
Menu 01 Set Clock
Menu 02 Set Crono (Programmable Thermostat)
Menu 03 Select Language
Menu 04 View Settings
Menu 05 State Stove (Fire Status)
Menu 06 Hours Work
Menu 07 Bank Data (protected by a password)
Menu 08 Reset Hours (protected by a password)
Menu 09 Default Settings (protected by a
password)
Menu 10 Select Recipe (protected by a password)
8
to the stove and the room in which it is installed. In any
case, when a problem arises, the pellets stop falling
immediately and the switch off phase is activated. The
corresponding alarm will be shown on the display. The
details can be seen in the "7.1 Explanation of Alarms" on
page 12.
5.8

Operating Precautions

• In case of faulty operation turn the stove off pressing
button no. 3.
•
•
after repeatedly trying to light the stove, must be
removed before further attempts.
• Do not use any fuels other than wood pellets.
• Should the ignition system be faulty, do not attempt to
6.2

Menu One - Setting the Clock

To set the clock, proceed as follows:
1. Remove and reset the electric supply of the stove
using the general switch on the back.
2. The display will show FINAL CLEANING and then
OFF.
3. Press button [7]. (Menu 01 Set Clock will appear)
4. Press [7] to enter into this menu. DAY CLOCK will
appear:
Display
01
02
03
04
05
06
07
OFF
5. Set the desired day by using [1] or [2] according to
the table shown below.
6.
7. TIME CLOCK will appear on the display and the
current time will be shown. Change the hours of the
Meaning
Monday
Tuesday
Wednesday
Thursday
Friday
Saturday
Sunday
Deactivated
Page 6