Filling The Pellet Hopper - Ravelli Camino Owners & Installation Manual

5.1.1
1. Ensure burn pot is clean and the burn pot holes are
visible.
2. Ensure the hopper is full of wood pellets.
3.
start its ignition process, going through several
ignition phases.
• Start – Loads pellets into burn pot, Igniter on
but combustion fan off
• Waiting Flame – Pellet loading continues,
Igniter on, combustion fan on
•
temperature) - Loads pellets, Igniter off,
combustion fan on
• Work – Pellet loading and combustion/
convection fan speed adjusted to power set
point
• Final Cleaning
combustion fan on Max speed until pre-set
exhaust temp is reached
5.1.2
1. Press [3] for 3 seconds.
2.
cooled down and both the exhaust fan and convection
fan have stopped.
During the working phase, the following settings should
be checked and adjusted as required:
• POWER SETTING (Button 5 on your remote
control)
• ROOM TEMPERATURE SETTING see "6.3.1
on page 9.
5.2

Filling the Pellet Hopper

Check hopper for foreign objects, then empty the bag
of pellets into the hopper. DO NOT OVER FILL as
miscellaneous pellets could smoke if left to rest on an
operating heater.
Store pellets at least one metre (1m) away from the
can be pulled out on a runner system so the hopper
maintenance .
6
- Pellet loading stops,
How to extract the stove:
Open the stove's door and extract the locking mechanism
lever using the corresponding hook (SUPPLIED) shown
in the illustration.
How to extract the stove:
Open the stove's door and extract the safety lever using the corresponding hook (SUPPLIED) shown in the illustration.
Just pull the lower grill outwards to extract the stove.
Hold the lower grill in the middle and pull the lower grill
outwards, it will pivot and the top will come forward, this
with wood pellets through the safety grill as indicated.
sure the door is open and the locking mechanism is in
Brochure for FLAT - 900 model
HOOK
Page 4