Cv Shaft Boot Inspection; Wheel Removal Front Or Rear - Polaris A09BG50AA User Manual

CV SHAFT BOOT
INSPECTION
Inspect the cv shaft boots in the front of the ATV for
damage, tears, wear, or leaking grease. If the rubber
boot exhibits any of these symptoms, replace the
boot. Refer to Chapter 7 for CV boot replacement, or
have you Polaris dealer replace the boot.
Inspect Boots
CONTROLS
Check controls for proper operation, positioning
and adjustment.
G
Brake control and switch must be
positioned to allow brake lever to
travel throughout
without contacting switch body.
WHEELS
Inspect all wheels for runout or damage. Check wheel
nuts and ensure they are tight. Do not over tighten the
wheel nuts.
entire range
WHEEL, HUB, AND SPINDLE
TORQUE TABLE
Item
Front Wheel Nuts
Rear Wheel Nuts
Front Spindle Nut
Rear Hub Retaining Nut
WHEEL REMOVAL FRONT OR
REAR
1. Stop the engine, place the transmission in gear
and lock the parking brake.
2. Loosen the wheel nuts slightly.
3. Elevate the side of the vehicle by placing a
suitable stand under the footrest frame.
4. Remove the wheel nuts and remove the wheel.
Front Wheel
Front Wheel Nuts (4)
27 ft. lbs. (34 Nm)
Rear Wheel
Rear Hub Nut
80 ft. lbs. (108 Nm)
MAINTENANCE
Specification
27 Ft. Lbs. (27 Nm)
50 Ft. Lbs. (68 Nm)
Refer to procedure listed in
Chapter 7
80 Ft. Lbs. (108 Nm)
Front Spindle Nut
See Ch. 7
Rear Wheel Nuts (4)
50 ft. lbs. (68 Nm)
Taper end faces
wheel for install.
2.39