Polaris A09BG50AA User Manual page 242

ELECTRICAL
SEALED LOW MAINTENANCE
BATTERY OFF- -SEASON
STORAGE
To prevent battery damage during extended periods
of non-use, the following basic battery maintenance
items must be performed:
GRemove the battery from the machine
and wash the case and battery tray
with a mild solution of baking soda
and water. Rinse with lots of fresh
water after cleaning.
GUsing a wire brush or knife, remove any
corrosion from the cables and
terminals.
GCharge at a rate no greater than 1/10 of
the battery's amp/hr capacity until
the voltage reaches 13.0VDC or
greater.
GStore the battery either in the machine
with the cables disconnected, or
store in a cool place.
SEALED LOW MAINTENANCE
BATTERY CHARGING
PROCEDURE
1. Remove the battery from the ATV to prevent
damage from leaking or spilled acid during
charging.
2. Charge the battery with a variable rate charging
output. Charge as needed to raise the voltage to
12.8VDC or greater.
3. Install battery in vehicle with positive terminal
toward the front. Coat threads of battery bolt with
a corrosion resistant Nyogelt Grease (PN
2871329).
4. Route cables so they are tucked away in front and
behind battery.
5. Connect battery cables.
WARNING
To avoid the possibility of sparks and explosion,
connect positive (red) cable first and negative (black)
cable last.
6. After connecting the battery cables, install the
cover on the battery and attach the hold down
strap.
10.26
CONVENTIONAL BATTERY
ACTIVATION/ SERVICE
To ensure maximum service life and performance
from a battery, perform the following steps.
NOTE: This section contains information for both
Conventional Lead--Acid batteries and Sealed Low
Maintenance batteries. Before service, identify the
battery type in the vehicle. Use the section that
applies to the battery.
WARNING
Battery electrolyte is poisonous.
sulfuric acid. Serious burns can result from con-
tact with skin, eyes or clothing. Antidote:
External: Flush with water.
Internal: Drink large quantities of water or milk.
Follow with milk of magnesia, beaten egg, or
vegetable oil. Call physician immediately.
Eyes: Flush with water for 15 minutes and get
prompt medical attention.
Batteries produce explosive gases.
sparks, flame, cigarettes, etc. away. Ventilate
when charging or using in an enclosed space.
Always shield eyes when working near batter-
ies. KEEP OUT OF REACH OF CHILDREN.
WARNING: The gases given off by a battery are
explosive. Any spark or open flame near a battery can
cause an explosion which will spray battery acid on
anyone close to it. Should there be contact with
battery acid, wash the affected area with large
quantities of cool water and seek immediate medical
attention.
NOTE:New Battery: Battery must be fully charged
before use or battery life will be significantly reduced
10-30% of the battery's full potential.
To activate a new battery:
1. Remove vent plug from vent fitting. Remove cell
caps.
2. Fill battery with electrolyte to upper level marks on
case.
3. Set battery aside to allow for acid absorption and
stabilization for 30 minutes.
4. Add electrolyte to bring level back to upper level
mark on case. NOTE: This is the last time that
electrolyte should be added. If the level becomes
low after this point, add only distilled water.
It contains
Keep