Polaris A09BG50AA User Manual page 122

BODY / STEERING / SUSPENSION
TORQUE SPECIFICATIONS
Item
Front A-Arm Attaching Bolt
Front A--Arm Ball JointStud
Nut
Handlebar Adjuster Block
Steering Post Nut
Steering Post Bushing Nuts
Steering Post Retainer Nuts
Rear Axle Nut -
(Tapered Roller Bearings)
(Left side)
Rear Axle Nut -
(Tapered Roller Bearings)
(Right Side)
Rear Shock Bolt (upper)
Rear Shock Bolt (lower)
Rear Wheel Hub Nut
Rear Wheel Nut
Strut Rod Retaining Nut
(Top)
Strut Casting Pinch Bolt
Tie Rod End Jam Nut
Tie Rod End Castle Nut
Tie Rod End Attaching Bolt
NOTE: Refer to exploded views throughout this
chapter for identification and location of components.
SPECIAL TOOLS
PART NUMBER
2870871
2870872
2870623
2871572
2871573
2871574
2871199
5.2
Specification
30 ft. lbs. (41 Nm)
25 ft. lbs. (35 Nm)
10-12 ft. lbs. (14-17 Nm)
75 ft.lbs. (16 Nm)
12 ft. lbs. (17 Nm)
12 ft. lbs. (17 Nm)
120 ft. lbs. (165 Nm)
8-10 ft. lbs. (11-14 Nm)
25 ft. lbs. (35 Nm)
25 ft. lbs. (35 Nm)
80 ft. lbs. (110 Nm)
50 ft. lbs. (69 Nm)
15 ft. lbs. (21 Nm)
15 ft. lbs. (20 Nm)
12-14 ft. lbs. (17-19 Nm)
23-24 ft. lbs. (32-33 Nm)
25-30 ft. lbs. (35-41 Nm)
TOOL
DESCRIPTION
Ball Joint
Replacement Tool
Shock Spanner
Wrench
Shock Absorber
Spring
Compression Tool
Strut Rod Wrench
LH Strut Spring
Compressor
RH Strut Spring
Compressor
Seal Sleeve
Installation Tool Kit
COVER/PANEL REMOVAL
To Remove: Perform These Steps:
Seat . . . . . . . . . . . . . . . . Pull release lever at left rear
of seat. Lift and pull seat
rearward, disengaging seat
from the front cab
Front Panel /
Headlight Cover . . . . . To Remove: Lift cover
and disengage tabs on both
sides and rear
Rear cab assembly . . To Remove: Seat, 3 screws,
nuts and washer plate at
rear of left footrest, 3
screws, nuts and washer
plate at rear of right footrest
4 bolts and flat washers from
top of cab assembly, 2
screws at rear of muffler
guard 2 screws at rear of
front cab on each side,
Disconnect taillight harness
Front cab assembly . To Remove: Seat, Fuel tank
cap, Headlight cover, 3
screws, nuts and washers
from left footrest, 3 screws,
nuts and washers from right
footrest, 2 screws at rear of
front cab on each side, 2
screws in front of cab under
the front cover. Choke and
key switch from indicator
panel.