Polaris A09BG50AA User Manual page 128

BODY / STEERING / SUSPENSION
STRUT ASSEMBLY - AWD (4X4)
15 ft. lbs.
(21 Nm)
Washer
Spacer Rubber
Upper Pivot Ball
Washer
Bolt
Spacer
Lower Pivot Ball
Spring Retainer
Spring
NOTE: Be sure steel insert notch (1) and strut casting notch are lined up and provide a channel for the
magnetic coil wires to lie in. If insert and strut do not match, strut replacement will be necessary.
Grease fitting (2) location. Check lubrication guide for recommended service intervals.
Specified pole gap is 0-.001" (0-.0254mm)
5.8
Nut
Washer
Strut Bumper
Spring Retainer
Clamp
18 ft. lbs.
15 ft. lbs.
(21 Nm)
1
Hub Coil
Seal Sleeve
Install Using Seal Sleeve
Installation Tool (PN 2871199)
(25 Nm)
Wire retainer
2