Polaris A09BG50AA User Manual page 20

MAINTENANCE
LUBRICATION, CONT.
7. Tie Rod End
Ill. Item
#
5 All Wheel Drive
Hubs -- ATVs
6 Ball Joint
7 Tie Rod Ends
8 Propshaft Yoke
9 Swing Arm Bush-
ings
10 Eccentric Housing
* More often under severe use, such as operated in water or under severe loads.
Semi-annually or 50 hours of operation (refer to Maintenance Schedule for additional information)
¡
More often under severe conditions (operating in water or hauling heavy loads)
Annually or 100 hours of operation (refer to Maintenance Schedule for additional information)
©
More often under severe conditions (operating in water or hauling heavy loads)
Grease conforming to NLGI No. 2, such as Polaris Premium All Season Grease, Conoco Superlube M or
¢
Mobilegrease Special
2.10
10. Rear Concentric Housing
5. AWD Hubs
4 or 8 O'clock position-
(end view)
6. Ball Joint
Lube Rec.
Polaris Demand Remove filler hole screw in hubs. Rotate wheels to
Drive Hub Fluid 4 or 8 O'clock position. If lubricant is not visible add
until it flows from filler hole. Reinstall screw.
Polaris All Season Locate grease fitting on back side of struts and
Grease¢ grease with grease gun.
Polaris All Season Lift boot. Clean away dirt and grease. Apply fresh
Grease¢ grease by hand and reassemble.
Premium U-Joint Locate fittings and grease - 3 pumps maximum
Grease
Polaris All Season Locate grease fitting on swing arm and grease with
Grease¢ grease gun.
Polaris All Season Locate grease fitting on eccentric housing and
Grease¢ grease with grease gun.
9. Swing Arm Bushings
DHF
8. Propshaft Yoke
(3 pumps max.)
Method Frequency*
Semi-annually
¡
Semi-annually
¡
Semi-annually
¡
Annually©
Semi-annually
¡
Annually©