Omron FH Series Operation Manual page 120

7 Offline Debugging
Additional Information
If the run mode (Status Flag: Run Mode) of the response area is OFF when simulation is exe-
cuted, open the Monitor window.
When the Monitor window is opened, the run mode changes to ON.
Precautions for Correct Use
• Simulations of sensor control programs can only be executed for a single FH vision sensor at
a time while the sensor settings are being edited offline. You cannot run simulations for multi-
ple FH vision sensors at the same time.
• The vision sensor currently being edited offline will have <Editing..> added to the end of the
[Type] in the Multiview Explorer.
• For simulation, the Sysmac error status is not registered as an event in the Sysmac Studio
troubleshooting window.
7 - 8 Vision System FH Series Operation Manual for Sysmac Studio (Z343)