Basic Design Flow 2 - Omron FH Series Operation Manual

2-2

Basic Design Flow 2

This section describes the flow for designing a system that uses a controller other than NJ/NX-series
CPU Unit.
New project settings
Create a project file.
(1) Starting Sysmac Studio
Start Sysmac Studio.
Refer to 3-3-1 Starting and Exiting the Sysmac Studio in Sysmac Studio Version 1 Opera-
tion Manual (Cat. No. W504-E1-08 or later).
(2) Designing a new project
Create a new project.
Select a vision sensor for the category and FH for the device.
Refer to 2-3 Creating a New Project on page 2-6
(3) Selecting sensor type
Select the sensor type and then establish an online connection.
Refer to step 3 on P. 2-7 of 2-3-1 Creating a New Project File from the Project Window on
page 2-6
Sensor configuration and settings
• Sensor configuration
(1) Creating an interface configuration for the sensor
Edit the interface configuration.
Refer to 5-1 Setting Procedure on page 5-3
• Sensor settings
(1) Editing the communication conditions
Edit the communication conditions of the sensor.
Refer to 5-1 Setting Procedure on page 5-3
Design
Create the processing flow.
(1) Creating flow
Refer to 2-6 Basic Operations of Flow Editing on page 2-30
(2) Editing processing units
Refer to 4-2 Editing a Processing Unit on page 4-4
Online debugging
Perform debugging using the actual device.
(1) Performing test measurement
Perform test measurement on sample work. Adjust the parameters if necessary.
Refer to Section 6 Online Debugging
Vision System FH Series Operation Manual for Sysmac Studio (Z343)
2 Basic Operations
2 - 5
2