Table of Contents
Advertisement
9
control circuit if it is positive, and connect blue wire if it is negative.
6.1.6 The default settings for tracker to connect central locking system is electric lock, if vehicle is air compressor lock,
please refer to the below descriptions about electric and air compressor lock switch command.
6.1.7 Fuel sensor diagram instructions: Please refer to the fuel sensor installation manual with the fuel sensor.
6.1.8 Connect the GPS and GSM antenna to the right connector, and find an appropriate place to fix the antennas to
make sure good reception.
6.2 Installation wiring diagram
6.2.1 Main unit installation wiring diagram
*Orange with black wire of JP1: Engine status detection, it is used to detect the engine started or not after automatically
start command, this wire connects to the power wire of fuel pump(for gasoline vehicle) or output wire of generator (for
diesel vehicle), and it has 9V-14V voltage after engine started.
Advertisement
Table of Contents
