Table of Contents
Advertisement
ShenZhen GETECH CO.,LTD
www.geeetech.com
3．
Printer Setting
3.1 Printer Speed
Set the running speed of printer as 1000 in the [printer settings] in order to avoid the collision
caused by high speed during the test. After the follow-up tests are completed, it can be changed
back to the original value.
Note: The speed of Z-axis should not be too high. 200 is OK.)
(
Travel feed rate: 1000mm/min
Z-Axis feed rate: 200mm/min
9
Advertisement
Table of Contents
Need help?
Do you have a question about the Duplicator 5 and is the answer not in the manual?
Questions and answers