Advertisement
Important
NP6251
Model
:
: LENS MOUNT ASSEMBLY
Location
: CHECKING MOVEMENT OF LENS MOUNT WITH YOUR HAND
Subject
: To communicate precautions to take in checking the movement of the lens mount with your hand after
Reason
replacing the mount wire or doing something else
: For checking the movement of the lens mount with your hand, do not turn the pulley (attached to the
Details
motor for movement in Y direction) with your hand. The edge of the pulley is sharp and the practice
of turning the pulley in an attempt to move the mount can lead to injuring your hand. Following the
instructions given in the service manual, first remove the plug for the power supply, hold the lens
mount near where it engages with the rail, and then move it slowly. (Refer to the figure below and the
section concerned in the service manual.)
Lens mount
Rail
Service Bulletin
Issued by Canon Europa N.V.
Fig. 1 Lens mount assembly
COPIER
No.:
6251-021
(FF-T01-H2-000042-01)
DATE:
10.08.99
Mount wire
Pulley
-
1 / 1 -
Advertisement
