Advertisement
1. Location for replacement parts
The figure shows the location for parts to be replaced and cable connections with the side guide
mount detached from the holding tray assembly and the side guide plate (rear) detached from the
side guide mount.
The method for installing cables is described on the next page.
Tighten the ground
wire terminal of the
motor cable along
with the screw.
Motor cable
Side guide plate
(rear) assembly
Connect cable
Holding tray driver PCB
Holding tray assembly
Side cable
Additional
Fig. 1 Location for replacement parts
Additional part
Side guide mount
Tighten the ground wire terminal of the
connect cable along with the screw.
6251-005 Rev. 1
-
2 / 5 -
Advertisement
