Advertisement
5) If the screwdriver does not go through the oval hole on the cam plate, loosen the fixing screw of the cam
plate and move the cam plate in the Y direction, then put the screwdriver through the oval hole. (See
Figures 6 and 7.)
Y direction
Fig. 6 Lens stage
6) With the screwdriver through the oval hole, tighten the cam fixing screw by lightly pressing the cam shaft
(shaded part of Figure 8) against the side of the rail (toward the lens).
7) After attaching the removed parts, turn the power switch ON and check the image for DIRECT copying.
If good resolution is not obtained, repeat Steps 1 to 6 again. When good resolution is obtained, bond lock
the cam plate fixing screw.
Cam plate
fixing screw
Cam plate
Lens
Fig. 8 Fixing cam shaft
Oval
hole
OK
Fig. 7 Positional relationship of round hole and oval
hole when the lens side hole is seen from the top
Round
hole
NG
NG
Cam plate
fixing screw
Cam shaft
6251-001
- 3/4 -
Advertisement
