Advertisement
3. A bend-up is provided on the front side size plate so as to keep the latch, while pushing on the tab,
from going past the normal position. To accommodate the change, ribs have been added, thereby
preventing contact of the hand with the bend-up. (Figures 3 and 4)
4. Sheet (Figure 5) to prevent the use of an Inch-size paper (when selecting an AB-size paper) has
been included in the packing for the copier.
: If any of the problems is noted, be sure to perform the following:
Servicing
1. Damage to the handle latch
Replace the handle latch (FB2-7756) with the new type.
2. Damage to the release arm
Replace the release arm (FB1-8478) with the new type.
3. Displacement of the torsion spring
Replace the latch (FB1-8699) with its tab and the front side size plate (FF5-1510) with the new
type.
4. Wrong setting of the paper width
If the user is not using Inch papers, attach the sheet (FB3-8711) for preventing wrong paper width
setting on the inside of the cassette.
For instructions, see the procedure that follows or the Installation Procedure included in the
packing for the copier.
Old type
Figure 3 Front side size plate
Old type
Figure 4 Tab for the latch
Figure 5 Sheet (for use in preventing Inch positioning;
Bend-up
New type (modification in shaded area)
Added ribs
New type (modification in shaded area)
4 sheets in one)
6251-016 Rev. 1
-
3 / 5 -
Advertisement
