Advertisement
2. Side guide plate (rear)
Installing the motor cable to the side guide plate (rear) (see Fig. 2)
Connect the connector of the cable to the PI sensor.
Temporarily clamp the cable ties at two locations of the cable and insert them into the respective
holes in the metal plate.
Tighten the cable ties while avoiding too much slack in cable (cut excess length of the cable ties).
Insert the cable through the edge saddle.
Connect the connector of the cable to the motor.
Ground wire terminal of the cable along with the metal plate on the side guide plate (rear).
Edge saddle
3. Side guide mount
Installing the motor cable and the side cable on to the side guide mount (see Fig. 3)
Mount the side guide plate (rear) to the side guide mount. Be sure to insert the motor cable into
the place as shown circled in Fig. 3.
Mount the side cable to the side guide mount.
Temporarily clamp the cable ties at three locations and insert them into the respective holes in the
side guide mount.
Tighten the cable ties while avoiding too much slack in cable (cut excess length of the cable ties).
Connect the connector of the motor cable and the side cable.
Temporarily clamp the cable ties at two locations of the motor cable.
Use screws to firmly retain the cable ties in position.
Tighten the cable ties while avoiding too much slack in cable at the part in the circle in Fig. 3 (cut
excess length of the cable ties).
Motor
Motor cable
Rear view
Side guide plate (rear)
Fig. 2 Side guide plate (rear)
PI Sensor
Cable ties
6251-005 Rev. 1
Metal plate
Ground wire
terminal
-
3 / 5 -
Advertisement
