Assign A User To The Mg-Rcv3 (Esprit Mode Only); Assign A Remote Control - Paradox MG-RCV3 Reference And Installation Manual

4.3.1 Assign a User to the MG-RCV3 (Esprit mode only)

SECTIONS
When a user presses a remote control's button, the MG-RCV3
transmits the corresponding user code to the Esprit control panel. The
control panel must receive a valid user code in order to process the
action. Sections [01] to [08] represent users 1 to 8 respectively (refer to
Table 4.1 on page 11).
How to assign a user to the MG-RCV3.
In step 4 in section 3.2 on page 10:
1. Enter a section number between [01] and [08].
2. Enter the [
3. Press [

4.3.2 Assign a Remote Control

SECTIONS
When connected to an Esprit control panel, assign up to eight Omnia
remote controls to users in the Esprit security system, whereby
sections [09] to [16] correspond to users 1 to 8 respectively (refer to
Table 4.1 on page 11). Each time a remote control's button is pressed, it
transmits its RF code to the MG-RCV3, which contains the
corresponding user information. In stand-alone mode, assign up to
eight remote controls to the module, whereby sections [09] to [16]
represent remote controls 1 to 8 (refer to Table 4.1 on page 11).
How to assign a remote control.
In step 4 in section 3.2 on page 10:
1. Enter a section number between [09] and [16].
2. Press [
illuminate.
3. Press and hold any button on the remote control until the keypad
beeps twice to confirm. If the keypad doesn't beep, repeat the
step until it does.
4. Press [
12
[01] [08]
TO
USER CODE
].
ENTER
The user code entered in sections [01] to [08] must match the
same user's code programmed in the Esprit control panel.
[09] [16]
TO
]. The keypad's "Ready" and "Arm" lights will
ENTER
].
ENTER
].
Reference & Installation Manual