Table of Contents
Advertisement
Programming Initial ISDN Options
Programming Initial ISDN Options
The following instructions explain the minimum programming required to
make the ISDN operational, plus the programming required for DID. Each
instruction includes a page number that references the relevant detailed
descriptions in Chapter 4. Default settings appear in bold.
Minimum Programming
Note:Option settings are in parenthesis ( ).
1. Set the system for ISDN operation.
2. If you are installing the ISDN while upgrading to a new DBS release,
3. Enter the system configuration (page 4-3).
3-4
Address
FF1 2# 1# 44# (1)#
0= T1 Operation
Options
1=ISDN Operation
perform the "ISDN Data Reset" command (page 4-28).
Note: DID settings are not maintained after the reset function.
Address
FF1 9# 1# (1)#
Options
0=No (retain settings)
1=Yes (clear settings)
Address
FF1 9# 4# 1# 1# (0-8)#
Options
0=DBS 40
1=DBS 72
2=DBS 96
3=DBS 40 + DBS 40 (ISDN must be in the slave cabinet.)
4=DBS 72 + DBS 40 (ISDN is not supported.)
5=DBS 72 + DBS 72 (ISDN must be in the slave cabinet.)
6=DBS 96 + DBS 40
7=DBS 96 + DBS 72
8=DBS 96 + DBS 96
DBS-EX22-530
Quick-Start Programming
Issued 10/23/98
Advertisement
Table of Contents
