Table of Contents
Advertisement
Appendix A. CPC-EX 2.3 Feature Update
Notes
• You must enter programming using the private password to view the
• If the system or remote password is set to the same value as the private
• If you are at an attendant key telephone when entering programming, you
Operation
To access the system using the private password at any display key telephone
(including an attendant telephone):
1. Go off-hook or press ON/OFF key.
2. Dial #98 followed by the 4-digit private password.
3. Press PROG followed by ##.
4. To exit system programming, hang up or press the ON/OFF key.
Terminal Programming Through a Direct Connection
When programming from a terminal connected to the RS-232C (SMDR) port,
perform the following steps:
1. Make certain the cables are configured and connected as outlined in
2. Make certain the DBS is in the SMDR mode by entering the following
3. Enter your terminal communications program and make sure your PC's
4. From your terminal communications program, type the following
Page A-12
private password address. The private password address will not appear
and is not accessible if programming is entered using the system or remote
password.
password, then the private password address will not be accessible. You
must first change the system or remote password to another value and then
log in again using the private password to have access to the private
password address.
must first enter #98 followed by the 4-digit private password before
entering programming (see below). Otherwise, the private password is not
accessible.
Section 300.
code from the attendant port:
ON/OFF #93
data communications settings match those of the DBS.
command:
DBS Manual - Revised April 2000
Section 530-ISDN Ref.
DBS-2.3-400
Advertisement
Table of Contents
