Appendix A. CPC-EX 2.3 Feature Update
6. When Password> is displayed, type the 4-digit remote or private
7. After the DBS responds with REMT>, type P and then press Enter.
8. Follow the directions on the screen to access the desired program. (See
ISDN Programming Flexibility
Description
The previous versions did not allow the programming flexibility to
accommodate certain central office ISDN configurations. This enhancement
allows the flexibility in programming to set the DBS parameters to match
certain central office provisioning.
Programming
The following programming addresses are no longer valid:
ISDN Upgrade Procedure:
1. New COP 1.07A is required on Primary Rate card(s).
2. Set system for ISDN function:
Page A-16
password.
"Terminal Programming Commands".)
Name
ISDN CO Type
Network Type
Auto Progress
SDN/MEGACOM
DBS Manual - Revised April 2000
Key Sequence
(1-64)
(1-64)
(1-64)
(1)
Section 530-ISDN Ref.
(0-3)
(0-1)
(0-1)
(0-1)
DBS-2.3-400