Table of Contents
Advertisement
Faucet Installation
Parts List for Faucet
Item Description
A
Escutcheon Plate
B
Black Rubber Washer
C
Black Locating Washer (use where A 1/2" hole
is available, reverse when mounting on stain-
less steel or when using drilled hole)
D
Lock Washer
E
Nut
F
Insert
G
Plastic Sleeve
H
1/4" Compression Nut
Gather and identify the faucet pieces
Step 5:
Place the escutcheon plate and the black rubber washer on the threaded stem. (Parts found in faucet
parts bag).
Step 6:
Insert the threaded stem through the hole in sink and let it rest on the sink top.
Step 7:
From the underside of the sink, slide on the black locating washer, lock washer, and nut onto the
threaded stem. Check the orientation of faucet then tighten the nut securely
Step 8:
Locate the 1/4" blue tube. Grab the following parts from the faucet parts bag and place onto the end of
the straight end of the tube: the brass nut, plastic sleeve (small tapered end of sleeve must point to the
end of tube), and then insert the plastic insert all the way into the end of the tube.
Step 9:
Push the assembled tube into the threaded stem until it stops. Slide the compression nut and plastic
sleeve until you can thread the nut onto the faucet. Use a wrench to securely tighten the compression
nut while continuing to push the tube into the faucet.
Step 10:
Push the other end of the blue tube with the 90° bend into the back of the filter module (behind the car-
bon filter)
B
D
F
H
Page 7
A
C
E
G
Advertisement
Table of Contents
