DeFelsko POSITECTOR DPM Full Manual page 13

Standard models
have one, fixed alarm.
When selected, the Gage will alert the user
when the surface temperature is less than
3°C (5°F) above the dew point temperature.
Enable by selecting the tick box. The Gage
will alert the user with an audio tone and the
LCD screen will reverse (see right) when
conditions may be unsuitable for painting.
Advanced models
allow the user to set up custom alarm
conditions for each reading in a dataset. Use the Up and Down
buttons to scroll through each value and corresponding operator.
Advanced models also allow the user to configure the gage to
send alerts via email.
For each reading, select between XX (off), ≥
(greater than or equal to), and ≤ (less than or
equal to) using the (-) and (+) buttons. Press the
down button and set the value using the
(-) and (+) buttons.
In alarm mode, if an alarm condition is met, the
relevant reading is displayed in red, and the
Alarm icon is displayed beside it (see image
at right). If the "Sound" checkbox was selected
in the Alarm Mode setup screen, an audio tone
will also be emitted.
To configure alarm notification via email, select
email Setup from the Alarm screen. Select the
tick box to enable and enter a valid email
address. An email test can be peformed by
selecting Test email. An internet connection is
required to send email alerts.
10