Konica Minolta BIZHUB 367 Installation Manual page 9

19. Network setting
Make the TCP/IP address setting for the network.
Note:
Consult the network administrator for the setting
value to be entered and make settings as
required.
(1) Select the function to be used as follows:
Menu → Utility → Administrator Settings → Enter
the Administrator Password → Network Settings
→ TCP/IP Settings → IPv4 Settings.
(2) Touch "Manual Input" of IP Application Method
and make the following settings.
IP Address: IP address of the controller
Subnet Mask: Subnet mask of the network, to
which the machine is connected
Default Gateway: IP address of the default gate-
way
(3) Touch "OK."
(4) Touch "OK" after the "TCP/IP Settings" screen is
displayed.
(5) Select the function to be used as follows:
Forward → Forward →Detail Settings → PING
Confirmation, and make the operation check of
TCP/IP.
20. Restarting the machine
Turn the power switch on the right side of the main
body OFF and ON again after 10 or more seconds
have passed.
21. Adjusting each option
If any of the following options are installed, adjust
each option as necessary. (See the installation man-
ual for each option.)
• Paper Feed Cabinet PC-413/PC-213/PC-113
• Reverse Automatic Document Feeder DF-628
• Finisher FS-534SD
• Punch Kit PK-520/PK-519
Note:
After completing all the steps, take a sample
copy, and confirm the image. If image troubles
occur, first turn OFF and ON the Main Power
Switch, and then redo the steps from E-7 "13.
Date & Time Setting/Time Zone Setting (Service
Mode)" to E-7 "15. Unit change."
22. Affixing the paper size label
Affix the paper size labels that correspond to the
sizes of paper used in each tray.
See the User Guide for instructions on setting paper
in each tray and configuring the paper types.
23. Installing the user's guide holder
Install the user's guide holder.
24. Installing the spacer
Install the supplied spacer.
E-9