Z-Wave ZTS-500 User Manual page 24

Check FLiRS / Always Listening Mode
Step Procedure / Description
In the System Main (SYS) screen:
Press > to navigate to the Operation Mode (Mod)
1
screen. Press + or – to entry the setting.
If the screen displayed "Batt", then the ZTS- 500
will operate in FLiRS mode after inclusion into a
Z-Wave network.
If the screen displayed "24V", then the ZTS- 500
2
will operate in Always Listening mode after
inclusion into a Z-Wave network.
Press > or < to back to the previous screen.
Z-Wave Add (Include) / Remove (Exclude) into/from Z-Wave network
Add (Include) ZTS-500 to Gateway / Controller
Step Procedure / Description
From the Standby screen, press > or < to navigate
to the Z-Wave screen and the Z-Wave LED will
1
continuously flash.
Tap + to include the ZTS-500 into the network.
There is a "z" animation during Z-Wave searching.
2
LED indication
LED indication
24
.
.