Features List; Wiring Requirements; Power Requirements - Z-Wave ZTS-500 User Manual

Features List

HVAC System Compatible:
Standard (Gas/Electric) or Heat Pump HVAC system s

Multi-stage System Compatible:
Standard HVAC Systems: 2 stages heating, 2 stages cooling, 2 stages fan

Heat Pump Systems: 2 stages heating, 2 stages cooling, 2 stages fan

Heat Pump change over valve:
Selectable change over with heat or cool (B or O output)

Fan system:
Selectable for gas or electric heat systems

Temperature Display, Indication and Control:
Temperature unit in °F or °C

Temperature Measurable Range: 32 - 99 °F / 0 - 37 °C

Temperature Setting Range: 41 - 99 °F / 5 - 37 °C

Adjustable Temperature Control Swing, Differential and Dead band

a) Swing: 1°F, 2°F, 3°F or 4°F ( 0.5°C, 1.0°C, 1.5°C or 2°C)
b) Differential: 1°F, 2°F, 3°F or 4°F ( 0.5°C, 1.0°C, 1.5°C or 2°C)
c) Dead band: 3°F, 4°F, 5°F or 6°F ( 1.5°C, 2.0°C, 2.5°C or 3°C)
Temperature sensor calibration

Filter replacement reminder after 500 hours usage (adjustable 500-4000hrs)

Defrost function and Out of temperature range control function

Energy saving mode

Short cycle start up protection

White LEDs display:
Resolution: 18 x 6 dots

View area: 64mm x 28mm

Status icons: 7

Wide viewing angle and high contrast ratio with 3 levels brightness control

Z-Wave:
Support "Frequently Listening Routing Slaves" (FLiRS) mode and "Always Listening" mode

Support Network Wide Inclusion (NWI) and Explore Frames

Support Security and Non- Security command

Support battery low and level report

Support Association Groups

a) Association Group-1 is a default status (AUTO) report channel in Z-Wave+ lifeline.
b) Association Group-2 is used for Heat Pump control
c) Association Group-3 is used for Compressor control
Advanced features through Z-Wave configuration parameters

Z-Wave Plus compliant

OTA (over-the-air) and USB firmware Upgradeability


Wiring Requirements:

Uses standard thermostat connections (C, RC,RH, W1, W2, Y1,Y2, G1, G2, O, B) – AWG #18

wires

Power Requirements:

Support AA x 2 or AA x 4 alkaline batteries (No C-wire required) or standard HVAC 24Vac

3