Notes - Z-Wave ZTS-500 User Manual

- The "✔" symbol will be displayed on screen
once the ZTS-500 is added into the network.
The Z-Wave disconnect icon will also be
removed from the standby screen.
3
- The "x" symbol will be displayed on screen if
there is no action (time out) or unable to include
the ZTS-500 into the network.

Notes:

1. It is recommended to perform the Remove/Exclude procedure before performing an
Add/Include procedure. This will ensure the ZTS-500 is not in any other Z-Wave network which
will disrupt the inclusion process.
2. If the inclusion process fails, try exclusion and/or resetting the ZTS-500 to factory default and
try inclusion again.
3. If the user navigates the menu from Brightness to the right side, the Z-Wave menu will be
skipped if the ZTS-500 is already included into the network and it will loop back to the Standby
screen by pressing the > key.
Remove (Exclude) ZTS-500 from Gateway / Controller
Step Procedure / Description
Press and keep holding > or < for 3 seconds to
navigate to the System Main (SYS) screen.
1
On the Z-Wave (Z-w) screen, press + or – to entry
the setting.
Tap + to exclude or include ZTS-500 from or into
the network.
2
Press < to cancel and back to the previous screen.
There is a "z" animation during Z-Wave searching.
3
LED indication
25
.
.