Table of Contents
Advertisement
Example: If Room temperature = 75°F, Dead band = 4°F, Swing = 1°F, Differential = 1°F
Heat Set point = 73°F, Cool Set point = 77°F
Then it will change the heat set point by +/- buttons.
If keep 73°F in heat set point, then the minimum of cool set point will be limited to 77°F,
st
=> 1
stage heater turns on when room temp is 72°F and off at 74°F.
nd
=> 2
stage heater turns on when room temp is 71°F and off at 73°F.
Output
o
70
F
nd
2
stage
Turn on in Heat
Off
Fan Mode
Step
Procedure / Description
To adjust the fan mode:
From the Standby screen, press > or < to
navigate to the Fan Mode screen and the Fan
LED will keep flashing.
1
When set to Auto:
- Electric-powered: Fan will run during heating
and cooling operation.
- Gas-powered: Fan will ONLY run during cooling
operation.
For one stage fan:
Press + or - to change the fan speed (Auto/On).
2
When set to On, the fan will stay ON.
For two stages fan:
Press + or - to change the fan speed
3
(Auto/High/Low).
When set to High/Low, the fan will stay ON.
Heat Set point
o
o
o
71
F
72
F
73
F
nd
2
stage
Turn off in Heat
st
1
stage
Turn on
in Heat
Diff
Swing
Swing
o
o
o
74
F
75
F
76
F
st
1
stage
Turn off
in Heat
Dead band
LED indication
17
Cool Set point
o
o
o
77
F
78
F
79
F
Temperature
Advertisement
Table of Contents
