Related Manuals for Z-Wave LinkedGo ST1000EZ0
Summary of Contents for Z-Wave LinkedGo ST1000EZ0
- Page 2 ○ Running Status: Fan Speed, Mode, Alarm. ○ Z-Wave Local network signal. ○ If you set thermostat as a master, you can see the switch. Use it close all A/C. ○ Slide indicator ○ Increase setting temperature. Hold 5 seconds for Add thermostat into Gateway.
- Page 5 Note: Upgrade method Step 1. Copy the “bl_update” folder into SD card. Step 2. Insert the SD card into the thermostat. Step 3. Switch to the third page, click "Settings", enter the password “888888”. Press the middle button. Step 4. Start upgrade, and it will be successful in about 2 minutes. Step 5.
-
Page 9: Z-Wave Network Setup
Slide to the third interface, find "About", select "Reset all settings", and confirm. Devices from multiple manufacturers in one network This product can be operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers. All non-battery operated nodes within the network will act... - Page 10 (gateway). All the reports sent via Lifeline group. Commands sent via Lifeline: COMMAND_CLASS_THERMOSTAT_MODE, COMMAND_CLASS_THERMOSTAT_SETPOINT, COMMAND_CLASS_THERMOSTAT_FAN_MODE, COMMAND_CLASS_SENSOR_MULTILEVEL, COMMAND_CLASS_CONFIGURATION, COMMAND_CLASS_DEVICE_RESET_LOCALLY Z-WAVE SPECIFICATION Configuration CC: Parameter Parameter Name Parameter Values Description Default value Number/Size Custom mode 0-standard mode...
- Page 11 ③Thermostat Fan Mode Command Set: Because of our refrigeration and heating control logic, the “off” bit is ignored. ④This device is a security enabled Z-Wave Plus product that is able to use encrypted Z-Wave Plus messages to communicate to other security enabled Z-Wave Plus products.