Replacing the power button board
Tools you need to complete this task:
v
Screws removed during this task:
To replace the status indicator board:
Complete the steps in
1
Remove the keyboard cover by following the steps in
2
cover" on page
Open the keyboard compartment by following the steps in
3
keyboard" on page
Important:
Swing the black connector clip upward, then lift the cable out of the connector. Be
4
careful not to touch or damage any other components.
82
Flat-blade driver
Phillips #0 screwdriver
2 black M2.5×5
(Keyboard cover)
"Preparing the notebook" on page
78.
80.
You do not need to disconnect the keyboard cable from the
system board to complete this procedure.
Clip
- OR -
3 black M2.5×4 (Power
button board)
Chapter 3: Replacing notebook components
Scribe or non-marring tool
55.
"Replacing the keyboard
"Replacing the