Acer TRAVELMATE 7730 Service Manual page 121

Remove the screws securing the button board assembly to the palm rest.
10
Separate the old button board from the metal bracket and install the new board
11
into the bracket.
Replace the button board assembly, then replace the screws removed in
12
Make sure the black button board connector clip is swung upward, insert the cable
13
into the connector, then swing the clip down to lock the connector in place.
Important:
Replace the palm rest by following the steps in
14
96.
Replace the LCD assembly by following the steps in
15
on page
Replace the keyboard by following the steps in
16
80.
Replace the keyboard cover by following the steps in
17
cover" on page
Replace the hard drive(s) by following the steps in
18
drive" on page 64
If the notebook has wireless networking built in, reconnect the wireless antennas
19
by following the steps in
Replace the wireless bay cover by following the steps in
20
wireless card" on page
Chapter 3: Replacing notebook components
The cable is correctly oriented if it is not twisted and the blue
band is facing up.
84.
78.
and "Replacing the secondary hard drive" on page
"Replacing the IEEE 802.11 wireless card" on page
67.
Screw
Screw
Screw
"Replacing the palm rest" on page
"Replacing the LCD assembly"
"Replacing the keyboard" on page
"Replacing the keyboard
"Replacing the primary hard
"Replacing the IEEE 802.11
Step 10.
73.
67.
111