General Guidelines; What Is In This Manual - ComAp InteliATS NT STD Reference Manual

General Guidelin

What is in this manual?

This manual describes the InteliATS
transfer switch application
NT
In li te ATS controller.
This manual is dedicated for
•
Automatic transfer switch panel builders
•
Operators of remote gen-sets (started rem
•
For everybody who is concerned with installation, operation an
InteliATS controller SW and HW versions compatibility
NT
Software InteliATS is compatible with the InteliATS
There are two modifications of the InteliATS
NT
InteliATS SW – STD and PWR which together with the appropriate archive file (IA-
X.X.AIL for STD HW 1.3, IA-NT-STD-X.X.AIL for STD HW > 1.3 and IA-NT-PWR-X.X
NT
InteliATS PWR or STD controller.
NT
Beside that the InteliATS
used when a low temperature ATS application is needed. In this case the Inteli
combined (purchased) with the IL-NT AMF 25 LT HW to obtain the low tempe
N :
OTE
Because of large variety of InteliATS
combination. Some of InteliATS
The data in this manual only describes the product and are not warranty of performance or
characteristic.
C !
AUTION
SW and HW must be compatible (e.g. IA-NT firmware and IA-NT HW) otherwise the function will be
disabled. If wrong software is downloaded, message HARDWARE INCOMPATIBLE appears on
controller screen. In this case use Boot load (jumper) programming – close Boot jumper and follow
instructions in LiteEdit, download correct
N :
OTE
omAp believes that all info
C
u pdate at any time. C omAp does not assume any responsibility for its use unless otherwise expressly
undertaken.
W !
ARNING
Remote control - InteliATS
controlled devices check, that nobody can perform remote operation.To be sure disconnect
- remote control via RS232 line
- input REM TRANSFER
- input REMOTE AUT
- input REMOTE TEST
or disconnect output Rem START/ST
NT
InteliATS STD, SW version 2.0, ©ComAp – June 2010
IA-NT- STD-2.0-Reference Guide.pdf
es
NT
STD (IA-NT-STD) software, which is designed for automatic
s and provides general information on how to install and operate the
otely from InteliATS
NT
HW - STD and PWR and two modificatio
software is compatible with IL-NT AMF HW 1.3 and
NT
parameters settings, it is not possible to describe any
NT
functions are subject of changes depend on SW version.
software.
rmation provided herein is correct and reliable and reserves the right to
NT
controller can be remotely controlled. In case of the work on the
OP and o utputs GCB CLOSE/OPEN and MCB CLOSE/OPEN
NT
)
d maintenance of the gen-set
NT
hardware v. 1.3 and higher.
rature ATS controller.
ns of the
NT-STD-HW_1.3-
.AIL) form the
higher too, which is
NT
SW must be
ATS
5