Connection To Plc - Mitsubishi Electric FX2N-8AD User Manual

FX2N-8AD Analog input block
5.

Connection to PLC

Connect the FX
FX /FX /FX
0N 1N
For connection to a main unit or extension block of the FX
required.
For connection to a main unit or extension block of the FX
FX -CNV-IF is required.
2NC
Please check power supply availability to determine the number of FX
be connected to the FX
A unit No. 0 to 7 is automatically assigned to each special unit or special block connected to a
PLC main unit from the one nearest to the main unit.
The data is read from and written to the FX
unit.
*1 Because the unit No.0 is assigned to the built-in CC-Link/LT master in the FX
unit numbers assigned to special extension units/blocks begins with No.1.
-8AD to the right side of a main unit, extension unit or extension block of
2N
/FX /FX /FX Series PLC with an extension cable.
2N 2NC 3U 3UC
/FX /FX /FX
0N 1N 2N
2NC
3UC
/FX /FX PLCs.
2NC 3U 3UC
*1
-8AD by FROM/TO instructions given by the main
2N
Connection to PLC 5
Series PLC, FX -CNV-IF is
2NC
Series PLC, FX -1PS-5V or
3UC
-8AD blocks that can
2N
-32MT-LT,
3UC
5-1