Table of Contents
Advertisement
FX2N-8AD Analog input block
6.
Wiring
6.1
Caution
1) Do not lay signal cable near to high voltage power cable or house them in the same trunking
duct. Effects of noise or surge induction may occur. Keep signal cables a safe distance of
more than 100 mm (3.94") from these power cables.
2) The terminal screws of the FX
drawing) suitable for use with these screws should be fitted to the cable for wiring.
Figure 6.1: Crimp Terminals
6.8 mm (0.27" )
or less
3) The terminal tightening torque is 0.5 to 0.8 N m. Tighten securely to avoid malfunction.
4) Cut off all phases of power source before installation or performing wiring work in order to
avoid electric shock or damage of product.
5) Replace the provided terminal cover before supplying power and operating the unit after
installation or wiring work in order to avoid electric shock.
-8AD are M3.5 (0.14"), therefore crimp style terminals (see
2N
For M3.5 (0.14")
6.8 mm (0.27")
For M3.5 (0.14")
or less
Wiring 6
6-1
Hide quick links:
Advertisement
Table of Contents
