Table of Contents
Advertisement
6
Press the MENU button four times to cancel
the menu mode.
and push the Operation lever .
When reading is completed, READ OK
appears.
1) Perform steps 1 to 4.
2) Push the Operation lever in the e or r
direction to select a character, then push it in
the q direction to move to the next character.
•
•
You can erase all characters using the
RESET button on the camera or the remote
control.
BARS
SHUTTER
SPEES SELECT
CH1 SELECT
CH2 SELECT
INPUT1
INT(L)
INT(R)
ON
INPUT1
INPUT2
OFF
OFF
INPUT2
MIC POWER+48V
AUDIO
REC
COUNTER
RESET/TC SET
ZEBRA
LCD
EVF DTL
Camera or Remote control
the Operation lever in the w direction at the left
end (or in q direction at the right end) of the
characters. Then press the Operation lever .
1) Perform steps 1 and 2.
2) Push the Operation lever in the e or r
direction to move to TITLE RELOAD, display
YES and press it again.
•
If WRITE NG FORMAT ERROR appears,
format the SD memory card. (Page 29)
•
If WRITE NG WRITE PROTECT appears,
release the protected status of the SD
memory card.
•
If WRITE NG CANNOT ACCESS appears,
before proceeding.
•
If WRITE NG ERROR appears, the SD
memory card may be defective. Replace it.
56
INPUT2
START/
ON
DATE/
PHOTO
STOP
OSD
TIME
SHOT
COUNTER RESET
TITLE
ZOOM
OIS
MULTI/
REC
A.DUB
P-IN-P
WFM
/REW
PLAY
FF/
Advertisement
Table of Contents
